How to Install a Backplate Latch Handle Pack
Disclaimer: These instructions are for replacing existing door hardware on a standard internal wooden door. Ensure the area is clean and free from dust before starting. Always support the door when working on hinges.
You will Need:
- Screwdriver
- Drill with appropriate drill bits
- Pencil
- Tape measure or ruler
- Chisel (if minor adjustments are needed)
Note: Both fixing options are provided. For a stronger and longer-lasting installation, we recommend using the bolt-through fixings where possible.

1. Prepare the Door:
Remove all existing hardware including handles, latch, and hinges.
Ensure all openings are clean and free from debris before installing new components.

2. Fit the Hinges:
Replace one hinge at a time to keep the door aligned. Position each new hinge in the existing recess on the door and frame, and secure it with the screws provided. Check the door opens and closes smoothly before continuing.

3. Fit the Tubular Latch
Insert the tubular latch into the hole on the edge of the door. Ensure the latch sits flush with the door edge.
Important:
Make sure the angled side of the latch faces the door frame so it retracts correctly when closing.
Secure the latch plate using the screws provided.
4. Insert the Spindles:
Insert the tubular latch into the hole on the edge of the door. Ensure the latch sits flush with the door edge.
Important:
Make sure the angled side of the latch faces the door frame so it retracts correctly when closing.
Secure the latch plate using the screws provided.

5. Position the Handles:
Place the handles onto the spindle on both sides of the door. Hold them in position and ensure they are straight and level.
6. Mark Fixing Points:
Using a pencil, mark the fixing holes of the backplate. Mark bolt-through holes if using bolt-through fixings.
7. Remove & Drill Pilot Holes:
Reinsert the spindle through the latch. Fit both handles back onto the spindle. Secure using bolt-through fixings or surface-mounted screws. Tighten all screws until secure.

8. Reassemble & Secure the Handles
Open and close the door to check it moves smoothly. Check the handles operate smoothly and the latch springs back correctly. Turn the thumb turn to check the lock engages and releases. From the outside, test the emergency release with a coin or flat screwdriver to make sure it unlocks the door.

9. Test the Door
Open and close the door to ensure smooth movement. Operate the handles to check the latch retracts and returns correctly. Make any small adjustments if needed.
Final Note:
You’ve now successfully installed your latch door handle pack. Always check all components operate smoothly before regular use.