XFORT Smart Fingerprint Door Lock

• Supports up to 50 fingerprints
• Records log of user access
• Auto-Lock can be enabled via app
• Low battery indicator warns you before the battery runs out
• 9v Battery Jump start ensuring uninterrupted operation

Smart Digital Door Lock
Disclaimer: Ensure the installation area is clean and free of obstructions before starting. Do not install the batteries or remove protective coverings until the lock is fully installed.

What's Required:
Screwdriver
Drill with appropriate drill bits
Template (provided with the product)
Pencil
Tape measure or ruler
 

Installation Steps
1. Remove Existing Door Hardware:

Unscrew and remove any existing lock, latch, or handle from the door.
Clean the area to prepare for the new lock installation.

2. Mark the Positions for the Latch and Bore Hole:

Use the template provided to mark the positions for the latch cutout on the door edge and the 54mm bore hole on the door face.
Double-check that your markings align properly for accuracy.
 

3. Adjust the Deadbolt:

Set the deadbolt length to either 60mm or 70mm by rotating and pulling out the face of the deadbolt, relative to your door's specifications.
 

4. Create the Latch Cutout:

Using the template, mark and cut out the latch recess on the door edge for the deadbolt.
 

5. Drill the Bore Hole:

Drill a 54mm bore hole in the door face, ensuring it aligns with the deadbolt cutout.
 

6. Install the Deadbolt:

Insert the deadbolt into the cutout, ensuring the arrow on the deadbolt points upwards.
Secure the deadbolt with the provided screws.
 

7. Prepare the Door Frame:

Mark and create the deadbolt mortice hole on the door frame in the corresponding position.
Install the dust box and strike plate securely using the screws provided.
 

8. Attach the External Unit:

Place the external unit of the lock against the door, ensuring the spindle goes through the middle hole of the deadbolt.
Push the connection cable through the bore hole using the gap underneath the deadbolt.
 

9. Install the Internal Base Plate:

Thread the connection cable through the rectangular slot on the internal base plate.
Ensure the spindle from the external unit passes through the larger hole in the base plate.
Attach the external unit to the base plate using the three longer screws provided.
 

10. Add the Rubber Casing:

Place the rubber casing over the installed internal base plate to protect the internal components.
 

11. Attach the Internal Unit:

Slide off the battery cover on the internal unit to reveal the battery slots.
Connect the connection cable to the internal unit via the rectangular slot in the bottom corner.
Position the internal unit over the base plate and align the spindle to fit correctly.
Secure the internal unit to the base plate using the four smaller screws:
Two screws go into the positions inside the battery slot.
Two screws go into the sides of the thumbturn.
 

12. Insert the Batteries:

Place the batteries into the corresponding slots on the internal unit.
Slide the battery cover back into place.
 

13. Test Your Lock:

Test both the mechanical and digital functions of the lock (e.g., thumbturn, keypad, or app).
Make any necessary adjustments to ensure smooth operation.
 

Final Note:
Once installed and tested, your smart digital door lock is ready for use. Refer to the user manual for further programming and setup instructions. Always double-check the security and alignment before regular use.